Language:

Professional tyre bladder manufacturer

We have always believe in establishing long term and
mutually beneficial business relationship with our customers .

GOOD AGING RESISTANCE FLAP FOR PROTECTING INNER TUBE

TYRE BUILDING BLADDER: CARCASS DRUM SLEEVE; SHAPING DRUM SLEEVE; SHAPING DRUM BLADDER; PUSH OVER BLADDER; TURN UP BLADDER

TYRE CURING BLADDER: AIR SPRING CURING BLADDER; B TYPE SEMI-STEEL RADIAL TYRE CURING BLADDER FOR PCR & LTR; C TYPE SEMI-STEEL RADIAL TYRE CURING BLADDER FOR PCR & LTR; B TYPE ALL STEEL RADIAL TYRE CURING BLADDER FOR TBR; A TYPE RADIAL TYRE CURING BLADDER FOR PCR & LTR; AB TYPE RADIAL TYRE CURING BLADDER FOR PCR & LTR; B TYPE CURING BLADDER FOR BIAS TRUCK & BUS (TBB) TIRE; B TYPE CURING BLADDER FOR BIAS INDUSTRIAL & OTR TIRE; B TYPE CURING BLADDER FOR RADIAL INDUSTRIAL & OTR TIRE; B TYPE CURING BLADDER FOR BIAS AGRICULTURAL (AG) TIRE; B TYPE CURING BLADDER FOR MERIDIAN AGRICULTURAL (MG) TIRE; B TYPE CURING BLADDER FOR MOTORCYCLE TIRE; B TYPE CURING BLADDER FOR CYCLE/MOTORCYCLE TIRE

INNER TUBE: FLAP; LIGHT TRUCKS,SMALL AND MEDIUM SIZED PASSENGER CAR TIRE INNER TUBE; TRACTOR DRIVING TIRE INNER TUBE; TRACTOR ORIENTED TIRE INNER TUBE; INDUSTRIAL VEHICLE TIRE INNER TUBE; TRUCKS AND BIG SIZED PASSENGER CAR TIRE INNER TUBE; OTR TIRE INNER TUBE

Detail Information

FLAP

Flap is aslo know as lining belt or mound layer , which is a ring tape used to protect the contact face of inner tube from rim wear .

It is mounted betwee the inner tube and the rim with a thick middle and thinning from inside to outside on both sides.

There is a center line on the outer surface of the flap, which is used for alignment during installation .

There is also a hole in the center line and the inner tube valve nozzle goes through from this hole .

The flap does not require high physical and mechanical properties of the rubber, but it should have good aging resistance .

Tubeless tyres fixed to deep rims and ultra-low pressure tyres fixed to special structural rims are compact and do not require flap .

We can install metal plates in the valve mouth area according to customers requirements.